Search results
Results From The WOW.Com Content Network
where is the specific energy, is the specific volume, is the specific entropy, is the molecular mass, here is considered a constant (polytropic process), and can be shown to correspond to the heat capacity ratio. This equation can be shown to be consistent with the usual equations of state employed by thermodynamics.
Specific energy has the same units as specific strength, which is related to the maximum specific energy of rotation an object can have without flying apart due to centrifugal force. The concept of specific energy is related to but distinct from the notion of molar energy in chemistry , that is energy per mole of a substance, which uses units ...
Specific Pump Power (SPP) is a metric in fluid dynamics that quantifies the energy-efficiency of pump systems. It is a measure of the electric power that is needed to operate a pump (or collection of pumps), relative to the volume flow rate. It is not constant for a given pump, but changes with both flow rate and pump pressure.
A schematic presentation of a gravitation water vortex power plant, showing the turbine in yellow. The gravitation water vortex power plant is a type of micro hydro vortex turbine system which converts energy in a moving fluid to rotational energy using a low hydraulic head of 0.7–3 metres (2 ft 4 in – 9 ft 10 in).
where q is the volume flux vector of the fluid at a particular point in the medium, h is the total hydraulic head, and K is the hydraulic conductivity tensor, at that point. The hydraulic conductivity can often be approximated as a scalar. (Note the analogy to Ohm's law in electrostatics. The flux vector is analogous to the current density ...
In the mild reach, the hydraulic jump occurs downstream of the gate, but in the steep reach, the hydraulic jump occurs upstream of the gate. It is important to note that the gradually varied flow equations and associated numerical methods (including the standard step method) cannot accurately model the dynamics of a hydraulic jump. [6]
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
Using only a low head drop in a river or tidal flows to create electricity may provide a renewable energy source that will have a minimal impact on the environment. Since the generated power (calculated the same as per general hydropower ) is a function of the head these systems are typically classed as small-scale hydropower, which have an ...