Search results
Results From The WOW.Com Content Network
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
P = 0.052 * mud weight * true vertical depth. taught in almost all petroleum engineering courses worldwide, the mud weight (MW) is expressed in pounds per U.S. gallon, and the true vertical depth (TVD) is expressed in feet, and 0.052 is a commonly used conversion constant that can be derived by dimensional analysis:
The principle of a well kill revolves around the influence of the weight of a fluid column and hence the pressure exerted at the wellbore's bottom. P = h g ρ {\displaystyle P=hg\rho } Where P is the pressure at a specific depth, h, within the column, g is the acceleration of gravity and ρ is the density of the fluid.
ppg – pounds per gallon; PPI – post production inspection/intervention; PPI – post pipelay installation; PPL – pre-perforated liner; pptf – pounds (per square inch) per thousand feet (of depth) – a unit of fluid density/pressure [citation needed] PPS – production packer setting; PPU – pipeline process and umbilical
See mud log for an example of the corrected d-exponent plotted on a mud log. The parameter is an extension ("correction", hence the "c" notation) to the d-exponent method previously used for estimating formation pore pressures. The extension consists of a correction for the mud weight in use, compared to "standard" mud for the region.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
This mud type can be used as a completion and workover fluid, a spotting fluid to relieve a stuck pipe and as packer or casing fluid. They are very good for "Gumbo" shales. The mud weight can be controlled from 7–22 lbs/gal. It is sensitive to temperature but does not dehydrate as in the case of water based mud as mentioned before.
HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To convert these units to SI units, one can use: 1 ppg ≈ 119.826 ...