Search results
Results From The WOW.Com Content Network
During World War II, the 251 cu in (4,107 cc) flathead six was used as the basis for the Chrysler A57 multibank tank engine. [5] The last automotive use of the Chrysler flathead inline-six was in 1968. It was replaced by the much more efficient OHV Slant-6 released in 1960, which appeared in most Dodge trucks starting in 1961. According to the ...
The Chrysler A57 Multibank is a 30-cylinder 1,253 cu in (20.5 L) engine that was created in 1941 as America entered World War II. It consists of five banks of inline-6 cylinder engines. It consists of five banks of inline-6 cylinder engines.
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
In the Chrysler literature, the Poly engines were also called single rocker shaft (SRS), while the Hemi engines were called dual rocker shaft (DRS). These engines replaced Chrysler's flathead inline-six in the division's lower-priced cars, and were themselves gradually replaced by the Chrysler A engine beginning in mid-1956.
A 1964 Rambler American with a 195.6 OHV engine. American Motors' first straight-six engine was the 196 cubic inch (195.6 cu in (3.2 L)) six produced from 1952 through 1965, initially as a flathead (L-head) side-valve, and later an overhead valve (OHV) version.
The Slant-Six is the popular name for a Chrysler inline-6 internal combustion engine with an overhead valve reverse-flow cylinder head and cylinder bank inclined at a 30-degree angle from vertical. Introduced in 1959 for the 1960 models, it was known within Chrysler as the G-engine. It was a clean-sheet design that began production in 1959 at ...
The M37's flathead Chrysler Straight-6 engine was carried over from the World War II-era WC vehicle line, as was most of the drivetrain. Using an engine and drivetrain derived from a widely-produced 1930s era passenger vehicle was in line with a long-standing military procurement strategy that attempted to use commercially produced vehicle ...