When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Spring pin - Wikipedia

   en.wikipedia.org/wiki/Spring_pin

   A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.

3. Rast & Gasser M1898 - Wikipedia

   en.wikipedia.org/wiki/Rast_&_Gasser_M1898

   The firing pin was located on a transfer piece on the frame of the revolver rather than the hammer, an advancement at the time. Its ammunition was similar to but not interchangeable with that of the 8mm French Ordnance. The cylinder could be removed by pulling down on a spring loaded screw and withdrawing the axis pin/ejector rod.

4. Spring (device) - Wikipedia

   en.wikipedia.org/wiki/Spring_(device)

   [citation needed] Spring characteristics: (1) progressive, (2) linear, (3) degressive, (4) almost constant, (5) progressive with knee A machined spring incorporates several features into one piece of bar stock Military booby trap firing device from USSR (normally connected to a tripwire) showing spring-loaded firing pin. A spring is a device ...

5. Pogo pin - Wikipedia

   en.wikipedia.org/wiki/Pogo_pin

   Variety of loose pogo pins and pogo pins in 3-pin assembly holders and with Pick and Place caps Sectional drawing of a pogo pin, showing the plunger, barrel, and spring. A pogo pin or spring-loaded pin is a type of electrical connector mechanism with spring plungers that is used in many modern electronic applications and in the electronics testing industry. [1]

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.

7. Anti-handling device - Wikipedia

   en.wikipedia.org/wiki/Anti-handling_device

   Pull fuzes — these are typically installed in secondary fuze wells located on the side or bottom of landmines. The fuze is normally connected to a thin wire attached to the ground, so the wire is automatically pulled if the mine is lifted, shifted or disturbed in any way. Simple pull-fuzes release a spring-loaded striker. More sophisticated ...