Ad
related to: revolver yoke or crane parts
Search results
Results From The WOW.Com Content Network
The Model 36 was designed in the era just after World War II, when Smith & Wesson stopped producing war materials and resumed normal production. For the Model 36, they sought to design a revolver that could fire the more powerful (compared to the .38 Long Colt or the .38 S&W) .38 Special round in a small, concealable package. Since the older I ...
From the side, a stout pin was inserted into the cartridge above the cap. The gun's hammer pushed the pin into the cap and set off the primer. A revolver using this method had a cylinder with chambers that were bored completely through with a slight channel where the pin rested. [25] This type of cylinder was first patented in France in 1854. [26]
changed yoke retention, radius studs, floating hand 629-3: 1989: hardened yoke and frame, longer stop notch, bolt block, fixed hand 629-4: 1993: changed rear sight leaf and extractor 629-5: 1997: Eliminate cylinder stop stud and serrated tang, MIM trigger and hammer, floating firing pin 629-6: 2001: Internal lock added 629-7: 2005: Two piece ...
The pivoting part that supports the cylinder is called the crane; it is the weak point of swing-out cylinder designs. Using the method often portrayed in movies and television of flipping the cylinder open and closed with a flick of the wrist can actually cause the crane to bend over time, throwing the cylinder out of alignment with the barrel.
In the early 1960s, Elmer Keith, Bill Jordan, and Skeeter Skelton, all noted firearms authorities and authors, lobbied Remington Arms and Smith & Wesson to introduce a new .41 caliber police cartridge with the objective of filling a perceived ballistic performance gap between the .357 and .44 Magnums, thus creating a chambering which they believed would be the ultimate for law enforcement ...
After a small prototype run of Model 10-6 revolvers in .357 Magnum caliber, Smith & Wesson introduced the Model 13 heavy barrel in carbon steel and then the Model 65 in stainless steel. Both revolvers featured varying barrel weights and lengths—generally three and four inches with and without underlugs (shrouds).
The Triple Lock, officially the Smith & Wesson.44 Hand Ejector 1st Model New Century, is a double-action revolver. It was and is considered by many, including handgun enthusiast and expert Elmer Keith, to be the finest revolver ever made. [1] Its popular name refers to its extra (third) locking lug on the cylinder crane.
The S&W Model 15 revolvers were replaced by the Beretta M9 pistol in 9×19mm caliber beginning in 1985, with complete turnover by the early 1990s. [2] S&W Model 15 revolvers reportedly remained in service in the United States Department of Defense for specific training purposes until summer 2022, when they were retired in favor of the SIG Sauer ...