When.com Web Search

  1. Ads

    related to: heat shrink and solder connectors for plastic

Search results

  1. Results From The WOW.Com Content Network
  2. Heat-shrink tubing - Wikipedia

    en.wikipedia.org/wiki/Heat-shrink_tubing

    Animation of heat-shrink tubing, before and after shrinking. Heat-shrink tubing (or, commonly, heat shrink or heatshrink) is a shrinkable plastic tube used to insulate wires, providing abrasion resistance and environmental protection for stranded and solid wire conductors, connections, joints and terminals in electrical wiring.

  3. Low pressure molding - Wikipedia

    en.wikipedia.org/wiki/Low_pressure_molding

    The polyamide temperature is not too hot for the electronics and does not re-melt or re-flow the solder. This is simply because the relative cold mold-set will absorb the brunt of the heat, thereby reducing the temperature that a circuit board may see. Millions of circuit boards are successfully over-molded without causing any harm in the process.

  4. Thin shrink small outline package - Wikipedia

    en.wikipedia.org/wiki/Thin_Shrink_Small_Outline...

    The Thin shrink small outline package has a smaller body and smaller lead pitch than the standard SOIC package. It is also smaller and thinner than a TSOP with the same lead count. Body widths are 3.0 mm, 4.4 mm and 6.1 mm. The lead counts range from 8 to 80 pins. The lead pitches are 0.5 or 0.65 mm.

  5. List of electronic component packaging types - Wikipedia

    en.wikipedia.org/wiki/List_of_electronic...

    TO-92: Plastic-encapsulated package with three leads; TO-99: Metal can package with eight radial leads; TO-100: Metal can package with ten radial leads, similar to TO-99; TO-126: Plastic-encapsulated package with three leads and a hole for mounting on a heat sink; TO-220: Through-hole plastic package with a (usually) metal heat sink tab and ...

  6. Heat sealer - Wikipedia

    en.wikipedia.org/wiki/Heat_sealer

    Heat seal connectors are used to join LCDs to PCBs in many consumer electronics, as well as in medical and telecommunication devices.. Heat sealing of products with thermal adhesives is used to hold clear display screens onto consumer electronic products and for other sealed thermo-plastic assemblies or devices where heat staking or ultrasonic welding are not an option due to part design ...

  7. Staking (manufacturing) - Wikipedia

    en.wikipedia.org/wiki/Staking_(manufacturing)

    Thermoplastic staking, also known as heat staking, is the same process except that it uses heat to deform the plastic boss, instead of cold forming.A plastic stud protruding from one component fits into a hole in the second component.