When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. Example (metric coarse): For M7.0×1.0, major minus pitch yields 6.0, but 6.1 also works well.

  3. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    It indicates the diameter of smooth-walled hole that a male thread (e.g. on a bolt) will pass through easily to connect to an internally threaded component (e.g. a nut) on the other side. For example, an M6 screw has a nominal outer diameter of 6 millimetres and will therefore be a well-located, co-axial fit in a hole drilled to 6 mm diameter.

  4. Log splitter - Wikipedia

    en.wikipedia.org/wiki/Log_splitter

    A Croco log splitter attached to a Kobelco excavator in Jyväskylä, Finland. A simple log splitter may be powered by an electric motor driving a hydraulic pump or by gasoline or diesel engine with or without a tractor. The non-electric versions can be used remotely where the splitter can be moved to the location of the cut wood source.

  5. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  6. IEC metric screw sized connectors - Wikipedia

    en.wikipedia.org/wiki/IEC_metric_screw_sized...

    IEC 61076-2-113 M12 connectors with screw-locking, power and signal contacts for data transmission frequencies up to 100 MHz: M12 Y-coding [6] IEC 61076-2-114 M8 connectors with screw-locking, power and signal contacts for data transmission frequencies up to 100 MHz : M8 D and P-coding

  7. Tap and die - Wikipedia

    en.wikipedia.org/wiki/Tap_and_die

    where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

  8. Hydraulic splitter - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_splitter

    The piston splitter requires a larger hole size diameters (usually 90mm, 95mm, 105mm and rarely 150mm or 200mm) than the darda splitter, which requires holes usually under 50mm. The cylinder diameters of the piston splitters are smaller than the holes by 10~15mm in diameter.

  9. Splitting maul - Wikipedia

    en.wikipedia.org/wiki/Splitting_maul

    A typical wood splitting maul has a head mass of 6 to 8 lb or approximately 2.7 to 3.6 kg, respectively. Traditionally, mauls have a wedge-shaped head, but some modern versions have conical heads or swiveling sub-wedges. The original maul resembles an axe but with a broader head. For splitting wood, this tool is much better than a typical axe.