Ads
related to: schlage keys cut by number chart blank
Search results
Results From The WOW.Com Content Network
A bit key with its main parts labelled. Bitting is the depth of key cuts on a cylinder key for a pin tumbler lock, often expressed as a number. Bitting also refers to the combination of key cuts on a bit key for a warded lock or lever tumbler lock. The exact geometry of modern keys is usually described by a code system. [1]
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Schlage (/ ʃ l eɪ ɡ / SHLAYG) [1] [2] is an American lock manufacturer founded in 1920 by Walter Schlage. Schlage was headquartered in San Francisco from its inception until it relocated to Colorado Springs, Colorado, in 1997. Schlage also produces high-security key and cylinder lines Primus, Everest, and Everest Primus XP.
The bitting code is used in conjunction with a key's Depth and Spacing Number to completely determine all relevant information regarding the key's geometry. [1] Each number in the bitting code corresponds to a cut on the key blade. For example, a bitting code of 11111 with Depth and Spacing Number 46 specifies a Kwikset key with five shallow cuts.
A key blank (sometimes spelled keyblank) is a key that has not been cut to a specific bitting. The blank has a specific cross-sectional profile to match the keyway in a corresponding lock cylinder. Key blanks can be stamped with a manufacturer name, end-user logo or with a phrase, the most commonly seen being 'Do not duplicate'. Blanks are ...
Key cut A square, rounded or V-shaped depression, filed or machined into a key, to allow the key to turn in its lock. In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin
Interchangeable cores require a notch at the tip of each key to properly align the peaks and valleys of each blade with the combinating pins in the chambers of the mechanism; as a consequence, these keys are always configured and cut from blade tip to bow. Conversely, conventional cylinders and removable cores use a shoulder near the bow of ...
The key to be duplicated is placed in one vise and the blank key to be cut in a corresponding vise under the cutting disk. The vise carriage is then into such position by means of a lateral-feed clutch that the shoulders of both the pattern and blank keys just touch the guide disk and cutter respectively.