Ads
related to: are tube amps dangerous
Search results
Results From The WOW.Com Content Network
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
Tube sound (or valve sound) is the characteristic sound associated with a vacuum tube amplifier (valve amplifier in British English), a vacuum tube-based audio amplifier. [1] At first, the concept of tube sound did not exist, because practically all electronic amplification of audio signals was done with vacuum tubes and other comparable ...
A valve audio amplifier or vacuum tube audio amplifier is a valve amplifier used for sound reinforcement, sound recording and reproduction. Until the invention of solid state devices such as the transistor , all electronic amplification was produced by valve (tube) amplifiers.
Mesa-Boogie Mark IV, a guitar combo amplifier. A guitar amplifier (or amp) is an electronic device or system that strengthens the electrical signal from a pickup on an electric guitar, bass guitar, or acoustic guitar so that it can produce sound through one or more loudspeakers, which are typically housed in a wooden cabinet.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
The circuit designs of these amplifiers, however, were new. The Portaflex bass amp was reissued, with updates intended to make it more appealing to modern bass players. The Ampeg GVT series, introduced around 2010, is a series of tube amplifiers built in South Korea, employing the Baxandall tone circuit. [27] [jargon]
He also asserted that most tube specialists consider fixed bias operation to be dangerous. [10] Despite this stance, fixed bias is commonly used in tube amplifiers today. Tomer identified the trend toward fixed bias designs in 1960 but was not certain about the reasons for it. [10]
In the early 2000s, the company worked with Bruce Egnater of Egnater Amplification to create the MTS (Modular Tube System) series of guitar amplifiers. These involve a single amp head consisting of the power amp and part of a preamp, and slots in the head (one for the RM20 head and combo, two for the RM50 head and combo and RM22 head, and 3 for the RM100 head and RM100C combo, and 12 for the ...