Search results
Results From The WOW.Com Content Network
A recipe in semiconductor manufacturing is a list of conditions under which a wafer will be processed by a particular machine in a processing step during manufacturing. [158] Process variability is a challenge in semiconductor processing, in which wafers are not processed evenly or the quality or effectiveness of processes carried out on a ...
Microfabrication is the process of fabricating miniature structures of micrometre scales and smaller. Historically, the earliest microfabrication processes were used for integrated circuit fabrication, also known as "semiconductor manufacturing" or "semiconductor device fabrication".
Wafer fabrication is a procedure composed of many repeated sequential processes to produce complete electrical or photonic circuits on semiconductor wafers in semiconductor device fabrication process. Examples include production of radio frequency amplifiers, LEDs, optical computer components, and microprocessors for computers. Wafer ...
split-fab (split fabrication, split manufacturing) – performing FEoL wafer processing at one fab and BEoL at another; sputtering (sputter deposition) – a thin film deposition method that erodes material from a target (source) onto a substrate; stepper – a step-and-scan system used in photolithography
Wafer mounting is a step that is performed during the die preparation of a wafer as part of the process of semiconductor fabrication. During this step, the wafer is mounted on a plastic tape that is attached to a ring. Wafer mounting is performed right before the wafer is cut into separate dies. The adhesive film upon which the wafer is mounted ...
Illustration of FEOL (device generation in the silicon, bottom) and BEOL (depositing metalization layers, middle part) to connect the devices. CMOS fabrication process. The front end of line (FEOL) is the first portion of IC fabrication where the individual components (transistors, capacitors, resistors, etc.) are patterned in a semiconductor substrate. [1]
Etching is a critically important process module in fabrication, and every wafer undergoes many etching steps before it is complete. For many etch steps, part of the wafer is protected from the etchant by a "masking" material which resists etching. In some cases, the masking material is a photoresist which has been patterned using photolithography.
Doing so allows much better focus over the tiny part of the mask, although it also makes the IC production process much slower. As of 2008, step-and-scan systems are the most widely used systems for high-end semiconductor device fabrication.