Search results
Results From The WOW.Com Content Network
Introduced in 1964, Turbo-Hydramatic use quickly spread across all GM divisions, and they became referred to simply as Hydramatics (like GM's original automatic of totally different design), except for the Super Turbine 400 model. By the 1970s, Turbo-Hydramatic variants had replaced all of GM's early automatic transmission designs. In Argentina ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
Transmission broadcast codes in 2005 for the ECCC transmission are 5ABN and 5MMN. [1] The 4T80-E is a hydramatic transmission and was developed for use with V8 front-wheel-drive cars, and at the time exclusively the Cadillac Northstar engine. [3] It was designed with extreme power handling capabilities at the time.
This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4-cylinder Ecotec line.
A Hydra-Matic 4L80 transmission at the Ypsilanti Automotive Heritage Museum The 4L80-E ( RPO MT1) is rated to handle engines with up to 440 ft·lbf (597 N·m) of torque. [ 2 ] The 4L80-E is rated to a maximum GVWR of 18,000 lb, depending on the axle and vehicle.
The transmission identification number or source serial number (chassis VIN) is usually located close to the transmission code. This number will contain a division identification number, the model year, and the assembly plant and production sequence (last 6 digits) of the vehicle identification number (VIN) stamped onto the transmission.
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
Toledo Propulsion Systems (previously called Toledo Transmission Operations, TTO, and Powertrain Toledo) is a 2.8 million square feet; 151 acres General Motors transmission factory in Toledo, Ohio. The plant manufactures and assembles GM’s six-speed, eight-speed and ten-speed rear-wheel-drive and nine-speed front-wheel-drive transmissions ...