Search results
Results From The WOW.Com Content Network
Grain size (or particle size) is the diameter of individual grains of sediment, or the lithified particles in clastic rocks. The term may also be applied to other granular materials . This is different from the crystallite size, which refers to the size of a single crystal inside a particle or grain.
It may also be presented in "cumulative" form, in which the total of all sizes "retained" or "passed" by a single notional "sieve" is given for a range of sizes. Range analysis is suitable when a particular ideal mid-range particle size is being sought, while cumulative analysis is used where the amount of "under-size" or "over-size" must be ...
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
Although such information contains long lists of sieve sizes, in practice sieves are normally used in series in which each member sieve is selected to pass particles approximately 1/ √ 2 smaller in diameter or 1/2 smaller in cross-sectional area than the previous sieve. For example the series 80mm, 63, 40, 31.5, 20, 16, 14, 10, 8, 6.3, 4, 2.8 ...
> 50% of coarse fraction retained on No.4 (4.75 mm) sieve clean gravel <5% smaller than No.200 Sieve GW well-graded gravel, fine to coarse gravel GP poorly graded gravel gravel with >12% fines GM silty gravel GC clayey gravel sand ≥ 50% of coarse fraction passes No.4 (4.75 mm) sieve clean sand SW well-graded sand, fine to coarse sand SP
AASHTO Soil Classification System (from AASHTO M 145 or ASTM D3282) General Classification Granular Materials (35% or less passing the 0.075 mm (No. 200) sieve)
[4] [5] This line of research can yield low-cost and real time particle size analysis. In all methods the size is an indirect measure, obtained by a model that transforms, in abstract way, the real particle shape into a simple and standardized shape, like a sphere (the most usual) or a cuboid (when minimum bounding box is used), where the size ...
Crushed sample is then separated from fine dust on a sieve, washed, dried and weighed. [6] The test reports loss of mass to abrasion and impact, expressed as a percentage of initial sample mass. [7] Maximum acceptable loss for the base course of the road is 45%; the more demanding surface course must be 35% or less. [1]