Ad
related to: frame to cycles per millisecond pressure to gauge oxygen sensor change locationsummitracing.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
This test does not only validate the cell. If the sensor does not display the expected value, it is possible that the oxygen sensor, the pressure sensor (depth), or the gas mixture F O 2, or any combination of these may be faulty. As all three of these possible faults could be life-threatening, the test is quite powerful.
The type of oxygen sensor used in most underwater diving applications is the electro-galvanic oxygen sensor, a type of fuel cell, which is sometimes called an oxygen analyser or ppO 2 meter. They are used to measure the oxygen concentration of breathing gas mixes such as nitrox and trimix . [ 9 ]
Oxygen transmission rate (OTR) is the measurement of the amount of oxygen gas that passes through a substance over a given period. It is mostly carried out on non-porous materials, where the mode of transport is diffusion, but there are a growing number of applications where the transmission rate also depends on flow through apertures of some description.
I suspect the cycling that the oxygen sensor output does isn't caused by the sensor, but the ECU richening and weakening the mixture. I.E. if a oxygen sensor was held in a steady unchanging perfect mixture the output would never change, much the same way as you don't see the voltage output of a battery cycle from high to low twice a second.
A heated metal wire (sensor wire, or simply sensor) suspended in a gas will lose heat to the gas as its molecules collide with the wire and remove heat. If the gas pressure is reduced, the number of molecules present will fall proportionately and the wire will lose heat more slowly. Measuring the heat loss is an indirect indication of pressure.
Both are measured in terms of cycle per second, or hertz. The PRF is normally much lower than the frequency. The PRF is normally much lower than the frequency. For instance, a typical World War II radar like the Type 7 GCI radar had a basic carrier frequency of 209 MHz (209 million cycles per second) and a PRF of 300 or 500 pulses per second.
This is commonly referred to as gauge pressure. Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other. It is a one-to-one relationship with an offset of -100 kPa for boost pressure. Thus, a MAP sensor will always read 100 kPa more than a boost sensor measuring the same conditions.
The SI unit of spatial frequency is the reciprocal metre (m −1), [1] although cycles per meter (c/m) is also common. In image-processing applications, spatial frequency is often expressed in units of cycles per millimeter (c/mm) or also line pairs per millimeter (LP/mm). In wave propagation, the spatial frequency is also known as wavenumber.