Search results
Results From The WOW.Com Content Network
The SAE has a separate viscosity rating system for gear, axle, and manual transmission oils, SAE J306, which should not be confused with engine oil viscosity. The higher numbers of a gear oil (e.g., 75W-140) does not mean that it has higher viscosity than an engine oil 20W-50.
It stipulates the lubricating oil requirements for 2-stroke gasoline engines, such as those used in motorcycles, general-purpose machines, and outboard motors, [1] and was established in 1994. [2] For 2-stroke oil, lubricity, cleanliness, exhaust smoke, and exhaust system blockage are evaluated using the test methods specified in JASO M 340, M ...
The same SAE system for designating motor oil viscosity also applies to synthetic oils. Synthetic oils are derived from either Group III, Group IV, or some Group V bases. Synthetics include classes of lubricants like synthetic esters (Group V) as well as "others" like GTL (methane gas-to-liquid) (Group III +) and polyalpha-olefins (Group IV).
SAE J306 is a standard that defines the viscometric properties of automotive gear oils. It is maintained by SAE International . [ 1 ] Key parameters for this standard are the kinematic viscosity of the gear oil, the maximum temperature at which the oil has a viscosity of 150,000 cP , and a measure of its shear stability through the KRL test.
Manufactured by solvent extraction, solvent or catalytic dewaxing, and hydro-finishing processes. Common Group I base oil are 150SN (solvent neutral), 500SN, and 150BS (brightstock) Group II – Saturates > 90% and sulfur < 0.03%, and SAE viscosity index of 80 to 120; Manufactured by hydrocracking and solvent or catalytic dewaxing processes.
Dimensionless numbers (or characteristic numbers) have an important role in analyzing the behavior of fluids and their flow as well as in other transport phenomena. [1] They include the Reynolds and the Mach numbers, which describe as ratios the relative magnitude of fluid and physical system characteristics, such as density, viscosity, speed of sound, and flow speed.
The fluid drive fluid coupling is partially filled with Mopar Fluid Drive Fluid, a special highly refined straight mineral oil with a viscosity of about 185 SUS at 100°F., excellent inherent oxidation stability, high viscosity index (100), excellent ability to rapidly reject air, very low natural pour point (-25°F.), ability to adequately ...
Consequently, if a liquid has dynamic viscosity of n centiPoise, and its density is not too different from that of water, then its kinematic viscosity is around n centiStokes. For gas, the dynamic viscosity is usually in the range of 10 to 20 microPascal-seconds, or 0.01 to 0.02 centiPoise. The density is usually on the order of 0.5 to 5 kg/m^3.