Search results
Results From The WOW.Com Content Network
After a small prototype run of Model 10-6 revolvers in .357 Magnum caliber, Smith & Wesson introduced the Model 13 heavy barrel in carbon steel and then the Model 65 in stainless steel. Both revolvers featured varying barrel weights and lengths—generally three and four inches with and without underlugs (shrouds).
The 2019 version comes standard with black synthetic finger groove grips, a black blade interchangeable front sight, and an adjustable white outline rear sight. The 610 is capable of firing both 10mm and .40 S&W cartridges, using moon clips that come standard with the revolver. [3] A full moonclip of .40S&W is being inserted into a Smith ...
A Smith & Wesson Model 642 revolver with an open cylinder and ergonomic rosewood grips. The Model 640 revolver has been in production since 1990 and was chambered for .38 Special. It was fitted with a standard barrel of 1-7/8 inch length. The second model had a slightly heavier and longer barrel of 2-1/8 inch length.
The JTL-E .500 S&W Magnum 12-inch is a German 5-shot double-action revolver chambered for the .500 S&W Magnum cartridge, developed by Janz-Präzisionstechnik GmbH. The revolver has a 12 in (300 mm) barrel with no muzzle brake or ports. It is able to fire even the heaviest .500 S&W Magnum bullets weighing 725 gr (47.0 g).
The PGU-12/B, issued only by the U.S. Air Force, had a greatly increased maximum allowable pressure rating of 20,000 psi (138 MPa), which was sufficient to propel the 130 grain (8.4g) FMJ bullet at 1,125 ft/s (343 m/s) from a 6-inch (150 mm) test barrel, and 950–1,000 ft/s (290–300 m/s) from a 4-inch (100 mm) revolver barrel. [4] The S&W ...
The Model 13 was the last revolver issued by the FBI. It was an unqualified success with Special Agents. The round-butt K-frame with 3” barrel in .357 Magnum proved to be an ideal sidearm for an investigative agency. [5] Apart from the USA, the ICAC of Hong Kong issued the revolver for replacement of the Smith & Wesson Model 10 revolver and ...
When first introduced by Smith & Wesson in 1935, it was known as the Registered Magnum. [citation needed] The model was essentially a custom-order revolver.Barrel lengths could be had in 1 ⁄ 4 inch (6.4 mm) increments from 3 + 1 ⁄ 2 to 8 + 3 ⁄ 4 inches (8.9 to 22.2 cm) inches in length.
Later models in this series include the .38 Military & Police Victory Model [2] and the S&W Model 10. [3] The Model 1905, as with the other .38 Hand Ejector models, is a six-shot revolver built on the Smith and Wesson K frame, with a swing-out cylinder chambered in .38 Special . [ 4 ]