Ads
related to: sparkfun inventor's kit v4.1.2 5 10 download
Search results
Results From The WOW.Com Content Network
SparkFun's Inventor's Kit, v4.0 An accelerometer and magnetic compass board from SparkFun. All products designed and produced by SparkFun are released as open-source hardware (OSHW), [5] with schematics, EAGLE files, and datasheets posted on each product page.
SparkFun_Inventor's_Kit,_v4.0.jpg (600 × 600 pixels, file size: 228 KB, MIME type: image/jpeg) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
1 KB, 0 KB 2.5 KB, 64 MB 14 6 12 September 10, 2013 [23] Arduino Yún is the combination of a classic Arduino Leonardo (based on the ATmega32U4 processor) with a Wi-Fi system on a chip (SoC) running Linino, a MIPS Linux based on OpenWrt. Arduino Leonardo [24] ATmega32U4 [22] 16 MHz Arduino 68.6 mm × 53.3 mm [ 2.7 in × 2.1 in ] USB 32U4 [22] 5 ...
These pins are on the top of the board, via female 0.1-inch (2.54 mm) headers. Several plug-in application shields are also commercially available. The Arduino Nano and Arduino-compatible Bare Bones Board [34] and Boarduino [35] boards may provide male header pins on the underside of the board that can plug into solderless breadboards.
The Bus Pirate can communicate via the following serial protocols, with line levels of 0–5.5 volts: 1-Wire, I²C, SPI, JTAG, asynchronous serial, and MIDI. It can receive input from a keyboard, and can output to a Hitachi HD44780 LCD controller. Other features: UART; 2- and 3-wire libraries with bitwise pin control; 0 – 6 volt measurement probe
BlueROV2 diving with ArduSub. The ArduPilot software suite consists of navigation software (typically referred to as firmware when it is compiled to binary form for microcontroller hardware targets) running on the vehicle (either Copter, Plane, Rover, AntennaTracker, or Sub), along with ground station controlling software including Mission Planner, APM Planner, QGroundControl, MavProxy, Tower ...
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module. [6] [7] Later, support for the ESP32 32-bit MCU was added.