Search results
Results From The WOW.Com Content Network
Concrete creep is essentially the sagging of concrete over time. Creep and shrinkage of concrete are two physical properties of concrete.The creep of concrete, which originates from the calcium silicate hydrates (C-S-H) in the hardened Portland cement paste (which is the binder of mineral aggregates), is fundamentally different from the creep of metals and polymers.
After sufficient setting and hardening of concrete (after 28 days), the progressive loss of capillary water is also responsible for the "drying shrinkage". It is a continuous and long-term process occurring later during the concrete life when under dry conditions the larger pores of concrete are no longer completely saturated by water. Thermal ...
Traditional concrete has a water:cement ratio of about 0.5, which refers to the weight of the water divided by the weight of the cement. A water:cement ratio of 0.5 provides good workability while keeping the amount of excess water in the mix fairly low. Without at least this much extra water, the concrete would be too dry to place.
Portland cement is the most common type of cement in general use around the world as a basic ingredient of concrete, mortar, stucco, and non-specialty grout. It was developed from other types of hydraulic lime in England in the early 19th century by Joseph Aspdin , and is usually made from limestone .
Concrete has a very low coefficient of thermal expansion, and as it matures concrete shrinks. All concrete structures will crack to some extent, due to shrinkage and tension. Concrete which is subjected to long-duration forces is prone to creep. The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1]
Cement powder in a bag, ready to be mixed with aggregates and water. [1] Cement block construction examples from the Multiplex Manufacturing Company of Toledo, Ohio, in 1905. A cement is a binder, a chemical substance used for construction that sets, hardens, and adheres to other materials to bind them together.
The humidity content of concrete is one of the main influencing factors of CO 2 diffusion in concrete. If concrete pores are completely and permanently saturated (for instance in submerged structures) CO 2 diffusion is prevented. On the other hand, for completely dry concrete, the chemical reaction of carbonation cannot occur.
When there is a probability that the temperature may fall below 5 °C within 24 hours of placing the concrete. The minimum strength before exposing concrete to extreme cold is 500 psi (3.4 MPa). CSA A 23.1 specified a compressive strength of 7.0 MPa to be considered safe for exposure to freezing.