Ads
related to: dual plane high rpm sbc carburetor cleaning tips
Search results
Results From The WOW.Com Content Network
The 1973–1974 L82 was a "performance" version of the 350 that still used the casting number 624 76cc chamber "2.02" heads but with a Rochester Quadra-jet 4bbl carburetor and dual-plane aluminum intake manifold, the earlier L46 350 hp (261 kW) 350 hydraulic-lifter cam, and 9.0:1 compression forged-aluminum pistons producing 250 hp (186 kW ...
A 4-barrel carburetor was mated to a high-rise, dual plane intake manifold feeding high-flow cylinder heads that are still considered among the best of that era. [ citation needed ] Its big ports used 2.02 in (51 mm) intake and 1.60 in (41 mm) exhaust valves.
Within 18 months, the design of the Chevy II was completed, including new 153 cu in (2,512 cc) four-cylinder and 194 cu in (3,185 cc) six-cylinder engines to power it. The 153 cu in engine had a 3 + 7 ⁄ 8-inch (98 mm) bore and 3 + 1 ⁄ 4-inch (82.6 mm) stroke, with two overhead valves per cylinder actuated by pushrods and a 1-3-4-2 firing order.
Carburetor heat uses hot air drawn from the heat exchanger or heat stove (a metal plate around the exhaust manifold) to raise the temperature in the venturi section high enough to prevent or remove any ice build-up. Because hot air is less dense than cold air, engine power will drop when carburetor heat is used.
Two-plane, or dynamic, balancing is necessary if the out-of-balance couple at speed needs to be balanced. The second plane used is in the opposite wheel. Two-plane, or dynamic, balancing of a locomotive wheel set is known as cross-balancing. [11] Cross-balancing was not recommended by the American Railway Association until 1931.
Weber pioneered the use of two-stage twin-barrel carburetors, with two venturis of different sizes (the smaller one for low-speed/rpm running and the larger one optimised for high-speed/rpm use). In the 1930s, Weber began producing twin-barrel carburetors for motor racing, where two barrels of the same size were used. These were arranged so ...
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control ( IMRC ) for four-valve engines, or the Charge Motion Control Valve ( CMCV ) for three-valve engines.
Unlike the later, second-generation 427, it was based on the W-series 409 engine, but with a longer 3.65 in (92.7 mm) stroke. A high-rise, two-piece aluminum intake manifold and dual Carter AFB carburetors fed a 13.5:1 compression ratio to produce an under-rated SAE gross 430 hp (321 kW) and 575 lb⋅ft (780 N⋅m).