Search results
Results From The WOW.Com Content Network
SPI timing diagram for both clock polarities and phases. Data bits output on blue lines if CPHA=0, or on red lines if CPHA=1, and sample on opposite-colored lines. Numbers identify data bits. Z indicates high impedance. The SPI timing diagram shown is further described below: CPOL represents the polarity of the clock.
The timing diagram example on the right describes the Serial Peripheral Interface (SPI) Bus. Most SPI master nodes can set the clock polarity (CPOL) and clock phase (CPHA) with respect to the data. This timing diagram shows the clock for both values of CPOL and the values for the two data lines (MISO & MOSI) for each value of CPHA.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.
This image is a derivative work of the following images: File:SPI_timing_diagram.svg licensed with Cc-by-sa-3.0-migrated, GFDL . 2006-12-20T02:37:46Z Cburnett 430x250 (226452 Bytes) Doh, messed up the upload.
In the example, the Response Time is 8.97 μs, therefore within specifications. This means that the Remote Terminal (RT) number 3 has responded to the Bus Controller query after 8.97 μs. The amplitude of the query is lower than the amplitude of the response because the signal is probed at a location closer to the Remote Terminal.
Devices implementing SPI are typically specified with line rates of 700~800 Mbit/s and in some cases up to 1 Gbit/s. The latest version is SPI 4 Phase 2 also known as SPI 4.2 delivers bandwidth of up to 16 Gbit/s for a 16 bit interface. The Interlaken protocol, a close variant of SPI-5 replaced the System Packet Interface in the marketplace.
Obtaining timing information in this manner, they reliably receive when the transmitter is sending at a slightly different speed than it should. Simplistic UARTs do not do this; instead they resynchronize on the falling edge of the start bit only, and then read the center of each expected data bit, and this system works if the broadcast data ...