Search results
Results From The WOW.Com Content Network
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
A translinear circuit is a circuit that carries out its function using the translinear principle. These are current-mode circuits that can be made using transistors that obey an exponential current-voltage characteristic—this includes bipolar junction transistors (BJTs) and CMOS transistors in weak inversion.
The VMOS structure has a V-groove at the gate region. A VMOS (/ ˈ v iː m ɒ s /) (vertical metal oxide semiconductor or V-groove MOS) transistor is a type of metal–oxide–semiconductor field-effect transistor ().
A typical use of these transistors is as a switch for moderate voltages and currents, including as drivers for small lamps, motors, and relays. [1] In switching circuits, these FETs can be used much like bipolar junction transistors, but have some advantages: high input impedance of the insulated gate means almost no gate current is required
Cross-sectional view of a MOSFET type field-effect transistor, showing source, gate and drain terminals, and insulating oxide layer. The field-effect transistor (FET) is a type of transistor that uses an electric field to control the current through a semiconductor. It comes in two types: junction FET (JFET) and metal-oxide-semiconductor FET ...
There are three types of unijunction transistor: The original unijunction transistor, or UJT, is a simple device that is essentially a bar of n-type semiconductor material into which p-type material has been diffused somewhere along its length, fixing the device parameter (the "intrinsic stand-off ratio"). The 2N2646 model is the most commonly ...
The common base current gain (or α) of a point-contact transistor is usually around 2 to 3, [4] whereas α of bipolar junction transistor (BJT) cannot exceed 1. The common emitter current gain (or β) of a point-contact transistor does not usually exceed 1, [4] whereas β of a BJT is typically between 20 and 200. Negative differential ...
Transistor–transistor logic (TTL) is a logic family built from bipolar junction transistors.Its name signifies that transistors perform both the logic function (the first "transistor") and the amplifying function (the second "transistor"), as opposed to earlier resistor–transistor logic (RTL) and diode–transistor logic (DTL).