Search results
Results From The WOW.Com Content Network
In US oil field units, hydrostatic pressure can be expressed as: HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To ...
The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked. {{convert|895|hPa|psi inHg atm mbar|1|abbr=on|lk=on}} → 895 hPa (13.0 psi; 26.4 inHg; 0.9 atm; 895.0 mbar) It is preferable to use "+" to separate output units when the first unit uses engineering notation; that ...
Example: For a column of fresh water of 8.33 pounds per gallon (lb/U.S. gal) standing still hydrostatically in a 21,000 feet vertical cased wellbore from top to bottom (vertical hole), the pressure gradient would be grad(P) = pressure gradient = 8.33 / 19.25 = 0.43273 psi/ft. and the hydrostatic bottom hole pressure (BHP) is then
The SI unit for pressure is the pascal (Pa), equal to one newton per square metre (N/m 2, or kg·m −1 ·s −2). This name for the unit was added in 1971; [7] before that, pressure in SI was expressed in newtons per square metre. Other units of pressure, such as pounds per square inch (lbf/in 2) and bar, are also in common use.
Simple conversion factors (0.433 for specific gravity and 0.052 for ppg) convert these values to a pressure gradient in psi per foot. Multiplying by the depth in feet gives the pressure at the bottom of the column. Of course, when the well is being drilled in metres as the depth unit, the maths gets more complicated.
is pressure head (which is actually a length, typically in units of meters or centimetres of water) is fluid pressure (i.e. force per unit area, typically expressed in pascals) is the specific weight (i.e. force per unit volume, typically expressed in N/m 3 units)
A pressure can be identified for every point in a body of fluid, regardless of whether the fluid is in motion. Pressure can be measured using an aneroid, Bourdon tube, mercury column, or various other methods. The concepts of total pressure and dynamic pressure arise from Bernoulli's equation and are
This pressure distribution is simply the pressure at all points around an airfoil. Typically, graphs of these distributions are drawn so that negative numbers are higher on the graph, as the C p {\displaystyle C_{p}} for the upper surface of the airfoil will usually be farther below zero and will hence be the top line on the graph.