Search results
Results From The WOW.Com Content Network
The asynchronous signalling methods use only one signal. The receiver uses transitions on that signal to figure out the transmitter bit rate ("autobaud") and timing, and set a local clock to the proper timing, typically using a phase-locked loop (PLL) to synchronize with the transmission rate. A pulse from the local clock indicates when another ...
The packets may be encapsulated in a data frame, with a frame synchronization bit sequence indicating the start of the frame, and sometimes also a bit synchronization bit sequence, typically 01010101, for identification of the bit transition times. Note that at the physical layer, this is considered as synchronous serial communication.
The search can be sequential (only consider one starting point at a time), or multiple candidate starting points may be considered at once. Advanced techniques continue searching even while synchronization is established, so that, if synchronization is lost, by the time the loss is noticed a new frame start position has been found. [2]
Synchronization is an emergent property that occurs in a broad range of dynamical systems, including neural signaling, the beating of the heart and the synchronization of fire-fly light waves. A unified approach that quantifies synchronization in chaotic systems can be derived from the statistical analysis of measured data.
The primary focus of this article is asynchronous control in digital electronic systems. [1] [2] In a synchronous system, operations (instructions, calculations, logic, etc.) are coordinated by one, or more, centralized clock signals.
Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of transmission, respectively. The start signal prepares the receiver for arrival of data and the stop signal resets its state to enable triggering of a new sequence.
This is because the resulting state of an asynchronous circuit can be sensitive to the relative arrival times of inputs at gates. If transitions on two inputs arrive at almost the same time, the circuit can go into the wrong state depending on slight differences in the propagation delays of the gates. This is called a race condition.
In an alternating current (AC) electric power system, synchronization is the process of matching the frequency, phase and voltage of a generator or other source to an electrical grid in order to transfer power. If two unconnected segments of a grid are to be connected to each other, they cannot safely exchange AC power until they are synchronized.