Ads
related to: flo by moen not working on toilet water pump
Search results
Results From The WOW.Com Content Network
A narrow passageway leads from the main water supply into the pressure chamber. It is the narrowness of this passage that meters the flow by slowing repressurizing of the pressure chamber after the action of a flush. The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
When these low flow fixtures first emerged manufactures generally did not make sufficient changes to the design besides reducing the amount of water used. As a result, many early low flow toilets did not remove solid waste very well. However, today there are many low-flow toilets that perform better than the older high flow models. [11]
Backflow is a term in plumbing for an unwanted flow of water in the reverse direction. [1] It can be a serious health risk for the contamination of potable water supplies with foul water . In the most obvious case, a toilet flush cistern and its water supply must be isolated from the toilet bowl.
The flush is triggered by a lever or handle that operates a simple diaphragm-like piston pump that lifts enough water to the crest of the siphon to start the flow of water which then completely empties the contents of the cistern into the toilet bowl. The advantage of this system was that no water would leak from the cistern excepting when flushed.
A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.
Crapper improved the S-bend trap in 1880. The new U-bend plumbing trap was a significant improvement on the "S" as it could not jam, and unlike the S-bend, it did not have a tendency to dry out and did not need an overflow. [7] The BBC nominated the S-bend as one of the 50 Things That (have) Made the Modern Economy. [8]
The momentum of the water flow in the inlet pipe against the now closed waste valve causes a water hammer that raises the pressure in the pump beyond the pressure caused by the water column pressing down from the outlet. This pressure differential now opens the delivery valve [5], and forces some water to flow into the delivery pipe [3].