Search results
Results From The WOW.Com Content Network
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
Only specially designed lamps according to STANAG 4381 [2] is allowed, but shall only be activated if terminal C is active. B Left Turn Signal: C Blackout marker lights according to STANAG 4381 [2] D Ground [NATO 3] E Tail lamps, clearance lamps/outline marker lamps and registration plate lamp: F Blackout stop lights according to STANAG 4381 [2 ...
The proximity pin, PP (also known as plug present), as shown in the SAE J1772 example pinout, describes the switch, S3, as being mechanically linked to the connector latch release actuator. During charging, the EVSE side connects the PP–PE loop via S3 and a 150 Ω R6; when opening the release actuator a 330 Ω R7 is added in the PP–PE loop ...
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
Jack (least-movable connector of a connector pair), jack connector (connector may have "male" pin contacts and/or "female" socket contacts) all types of connectors, including pin headers. JP: Jumper (link) K: Relay or contactor: L: Inductor or coil or ferrite bead: LD, LED: LED: often changed to "D" for diode LS, SPK: Loudspeaker or buzzer: M ...
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...