Ads
related to: critical range of rpm for aluminum heads for 350
Search results
Results From The WOW.Com Content Network
The 1973–1974 L82 was a "performance" version of the 350 that still used the casting number 624 76cc chamber "2.02" heads but with a Rochester Quadra-jet 4bbl carburetor and dual-plane aluminum intake manifold, the earlier L46 350 hp (261 kW) 350 hydraulic-lifter cam, and 9.0:1 compression forged-aluminum pistons producing 250 hp (186 kW ...
The J-2 engine also had a slightly thinner head gasket, raising compression to 10.0:1. It was advertised with gross power and torque ratings of 312 hp (233 kW) at 4600 rpm and 415 lb⋅ft (563 N⋅m) at 2800 rpm. Oldsmobile charged $83 for the J-2 option with the three-speed manual (or in the 98), [7] $314 with the automatic. [8]
Aluminum (TÜ2 onwards) ... DOHC: Compression ratio: 16.5-18.0:1: RPM range; Max. engine speed: 4750: Combustion; ... @ 4000 rpm: 350 N⋅m (258 lb⋅ft) @ 2000 ...
The HiPo engine was used in modified form by Carroll Shelby for the 1965–1967 Shelby GT350, receiving special exhaust headers, an aluminum intake manifold, and a larger 4-barrel Holley 715 CFM carburetor, which raised rated power to 306 bhp (310 PS; 228 kW) at 6,000 rpm and 329 lb⋅ft (446 N⋅m) at 4,200 rpm of torque.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The solid lifter version was capable of being operated in the upper 6000 rpm range, and when installed in the 1965 Corvette, was factory-rated at 425 hp (317 kW). Introduced in 1970, the 402 cu in (6.6 L) was a 396 cu in (6.5 L) bored out by 0.03 in (0.76 mm).
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
Peak torque is up 8 pound-feet (11 N⋅m) from the older "DE" engine at 268 lb⋅ft (363 N⋅m) and the torque curve is higher and flatter across most of the rpm range, and especially in the lower rpm range. The VQ35HR was utilized in rear-wheel-drive platforms while the VQ35DE continued to power Nissan's front-wheel-drive vehicles.