Search results
Results From The WOW.Com Content Network
A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [ clarification needed ] stands, and uses tension between the stands as well as compressive force from work rolls [ clarification needed ] to reduce the thickness of steel.
The federal weight limits for CMVs are 80,000 pounds (36,000 kg) for gross weight (unless the bridge formula dictates a lower limit), 34,000 pounds (15,000 kg) for a tandem axle, and 20,000 pounds (9,100 kg) for a single axle. [9] A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but ...
A quick-start guide or quickstart guide (QSG), also known as a quick reference guide (QRG), is in essence a shortened version of a manual, meant to make a buyer familiar with their product as soon as possible. This implies the use of a concise step-based approach that allows the buyer to use a product without any delay, if necessary including ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
A multi-link type rear independent suspension on an AWD car. The anti-roll bar has some yellow paint on it. Independent suspension is any automobile suspension system that allows each wheel on the same axle to move vertically (i.e. reacting to a bump on the road) independently of the others.
5-link live axle suspension. In automotive suspensions, a suspension link, control link or link is a suspension member, that attaches at only two points. One point being the body or frame of the vehicle and the other point attaching to the knuckle, upright, axle or another link. The link pivots on either a bushing or a ball joint at each ...
/ = the fore of the rear axles is steered (pusher axle) * = the rearmost of the rear axles is steered (tag axle) C = number of steered wheels - = separates axle groups and/or different axle functions (6x4-2 is 6x6 with undriven rear axle) Basis is always the standard configuration, meaning a steered front axle and a non-steered driven rear axle.
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...