Search results
Results From The WOW.Com Content Network
A rake is an architectural term for an eave or cornice that runs along the gable of the roof of a modern residential structure. It may also be called a sloping cornice, a raking cornice. The trim and rafters at this edge are called rakes, rake board, rake fascia, verge-boards, barge-boards or verge-or barge-rafters. [3]
The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the columns. The guttae or drip edge was mounted on the fascia in the Doric order, below the triglyph.
Overhanging eaves forming shelter around the building are a consequence where the gable wall is in line with the other walls of the buildings; i.e., unless the upper gable is recessed. Saltbox, catslide: A gable roof with one side longer than the other, and thus closer to the ground unless the pitch on one side is altered.
Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.
Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [7] The line on the ground under the outer edge of the eaves is the eavesdrip, or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.
Robert Rowllins of Salisbury, N.H., finishes up a four-hour session of raking leaves out front of his Salisbury, N.H. home, Thursday, Oct. 29, 2009.
In steel construction, the term purlin typically refers to roof framing members that span parallel to the building eave, [5] and support the roof decking or sheeting. The purlins are in turn supported by rafters or walls. Purlins are most commonly used in Steel Framed Building Systems, where Z-shapes are utilized in a manner that allows ...
A rafter is one of a series of sloped structural members such as steel beams that extend from the ridge or hip to the wall plate, downslope perimeter or eave, and that are designed to support the roof shingles, roof deck, roof covering and its associated loads. [2] A pair of rafters is called a couple.