Search results
Results From The WOW.Com Content Network
The 15T scale employs a 15-kgf load on a 1 ⁄ 16-inch-diameter (1.588 mm) hardened steel ball, and can be used on sheet metal. The B and C scales overlap, such that readings below HRC 20 and those above HRB 100, generally considered unreliable, need not be taken or specified. Typical values include:
Mill finish is the surface texture (or finish) of metal after it exits a rolling mill, extrusion die, or drawing processes, including sheet, bar, plate, or structural shapes. This texture is usually rough and lacks lustre; it may have spots of oxidation or contamination with mill oil.
Turned, ground, and polished (TGP) is a classification of finishing processes often used for metal shafting. Turning (on a lathe) creates straight round bars without the strain induced by cold drawing, while grinding and polishing improves the surface finish and roundness for high dimensional accuracy. [1]
It is produced by polishing the metal with a 120–180 grit belt or wheel finish and then softened with an 80–120 grit greaseless compound or a medium non woven abrasive belt or pad. #4 Dairy or sanitary finish. This finish is commonly used for the medical and food industry and almost exclusively used on stainless steel.
The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.
Surface finish, also known as surface texture or surface topography, is the nature of a surface as defined by the three characteristics of lay, surface roughness, and waviness. [1] It comprises the small, local deviations of a surface from the perfectly flat ideal (a true plane ).
Tumble finishing, also known as tumbling or rumbling, [1] is a technique for smoothing and polishing a rough surface on relatively small parts. In the field of metalworking , a similar process called barreling , or barrel finishing , [ 2 ] works upon the same principles.
Superfinishing, also known as microfinishing [1] and short-stroke honing, is a metalworking process that improves surface finish and workpiece geometry. This is achieved by removing just the thin amorphous surface layer of fragmented or smeared metal left by the last process with an abrasive stone or tape; this layer is usually about 1 μm in magnitude.