Ad
related to: us loading gauge
Search results
Results From The WOW.Com Content Network
A loading gauge is a diagram or physical structure that defines the maximum height and width dimensions in railway vehicles and their loads. Their purpose is to ensure that rail vehicles can pass safely through tunnels and under bridges, and keep clear of platforms, trackside buildings and structures. [1]
The gauge was known as "Texas gauge" while required by Texas law until 1875, [4] and used by the New Orleans, Opelousas and Great Western Railroad (NOO&GW) until 1872, and by the Texas and New Orleans Railroad until 1876. The New England railways were similarly standard-gauged in the 1870s.
For standard gauge railways, double stacking maximum height shall be 6.15 m (20 ft 2 in). For Indian gauge railways, double stacking maximum height shall be 7.1 m (23 ft 4 in), and minimum overhead wiring height shall be 6.5 or 6.75 m (21 ft 4 in or 22 ft 2 in) above rails.
Standard gauge is defined both in metric and in imperial units. It is the most widely-used gauge worldwide, ab out 60% of the world uses this track. [92] 1,440 mm 4 ft 8 + 11 ⁄ 16 in: Switzerland St. Moritz–Corviglia funicular (upper section of 1,616 metres or 5,302 feet route-length only - lower section is 1,200 mm (3 ft 11 + 1 ⁄ 4 in ...
The main lines were built to steam railroad standards, but from Bellwood east the track was built to the much smaller “L” loading gauge. To fit that cars could only be 8 feet 7 inches (2.62 m) wide at the floor, about 55 feet (16.8 m) feet long, and needed radial couplers.
A narrow-gauge railway (narrow-gauge railroad in the US) is a railway with a track gauge narrower than 1,435 mm (4 ft 8 + 1 ⁄ 2 in) standard gauge. Most narrow-gauge railways are between 600 mm ( 1 ft 11 + 5 ⁄ 8 in ) and 1,067 mm ( 3 ft 6 in ).
The minimum track spacing can be derived from the loading gauge. The European Berne Gauge has a width of 3,150 mm (10 ft 4 in). The minimal distance to structures on the side of the track is half of it but that is doubled again for double track lines. As the carriage can sway and bounce within the rail gauge, one adds 100 mm (3.9 in) and with a ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Help; Learn to edit; Community portal; Recent changes; Upload file