Ad
related to: lpg mounded bullet diameter calculator for sale cheap craigslist
Search results
Results From The WOW.Com Content Network
The 8×64mm S (also unofficially known as the 8×64mm S Brenneke) (the S means it is intended for 8.2 mm (.323 in) groove diameter bullets) is a rimless bottlenecked centerfire cartridge developed as a military service round for the German Army who never issued it.
A very-low-drag bullet (VLD) is primarily a small arms ballistics development of the 1980s–1990s, driven by the design objective of bullets with higher degrees of accuracy and kinetic efficiency, especially at extended ranges.
The Taylor KO factor multiplies bullet mass (measured in grains) by muzzle velocity (measured in feet per second) by bullet diameter (measured in inches) and then divides the product by 7,000, converting the value from grains to pounds and giving a numerical value from 0 to ~150 for normal hunting cartridges.
A .257 bullet has a metric bullet diameter of 6.53 mm. However, in Europe cartridge designation nomenclature for a large part relies on the bore diameter. As the bore diameter of the .257 Weatherby Magnum is .250 inches this would make it a 6.35 mm caliber cartridge which uses 6.5 mm bullets (not to be confused with 6.5 mm caliber cartridges ...
This twist rate was chosen since the bullet jackets used in the 1930s were not strong enough to cope with the forces generated by the magnum muzzle velocities of the 8×68mm S. The 240 mm (1 in 9.45 in) twist rate normally found in the 8×57mm IS makes the 8×68mm S combined with modern bullets with jackets designed for magnum cartridges an ...
The 8×60mm S bullet diameter is 8.22 mm (.323 in) as found in the 8×57mm IS. The new cartridge used the same bullet and therefore only the chamber of the rifle had to be modified (reamed out by 2 mm plus 1 mm of neck extension) to accommodate the slightly longer case. This operation was easily performed on Gewehr 98 and Karabiner 98k rifles ...
Originally designed with a 1-in-14 twist barrel, the 40 grain .22 Hornet bullet was the standard load. It could also be loaded with lighter or heavier-weight bullets available at that time for the .22 Hornet as well as most bullet weights up to 50 grains such as that used by the .222 Remington (5.7×43mm). [ 4 ]
This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range. Case length refers to the round case length. OAL refers to the overall length of the loaded round. All measurements are given in millimeters, followed by the equivalent in inches between parentheses.