Search results
Results From The WOW.Com Content Network
In applied mathematics, an Akima spline is a type of non-smoothing spline that gives good fits to curves where the second derivative is rapidly varying. [1] The Akima spline was published by Hiroshi Akima in 1970 from Akima's pursuit of a cubic spline curve that would appear more natural and smooth, akin to an intuitively hand-drawn curve.
This process mimics that used in early cartoon films. Master animators would draw key frames of the film, then, junior animators would draw the in-between frames. This is called inbetweening or tweening and the overall process is called "key frame animation". To make these motions appear realistic, interpolation algorithms have been sought ...
The basic operation of linear interpolation between two values is commonly used in computer graphics. In that field's jargon it is sometimes called a lerp (from linear interpolation). The term can be used as a verb or noun for the operation. e.g. "Bresenham's algorithm lerps incrementally between the two endpoints of the line."
Comparison of a slow down video without interframe interpolation (left) and with motion interpolation (right) Motion interpolation or motion-compensated frame interpolation (MCFI) is a form of video processing in which intermediate film, video or animation frames are generated between existing ones by means of interpolation, in an attempt to make animation more fluid, to compensate for display ...
There exist other end conditions, "clamped spline", which specifies the slope at the ends of the spline, and the popular "not-a-knot spline", which requires that the third derivative is also continuous at the x 1 and x n−1 points. For the "not-a-knot" spline, the additional equations will read:
More interesting is the case when the inclination degrees of layer lines are not the same for the base and revealing layers. Figure 7 shows an animation of a superposition images where the inclination degree of base layer lines is constant (10 degrees), but the inclination of the revealing layer lines oscillates between 5 and 15 degrees.
Along any other straight line, the interpolant is quadratic. Even though the interpolation is not linear in the position (x and y), at a fixed point it is linear in the interpolation values, as can be seen in the (matrix) equations above. The result of bilinear interpolation is independent of which axis is interpolated first and which second.
Polynomial curves fitting points generated with a sine function. The black dotted line is the "true" data, the red line is a first degree polynomial, the green line is second degree, the orange line is third degree and the blue line is fourth degree. The first degree polynomial equation = + is a line with slope a. A line will connect any two ...