Search results
Results From The WOW.Com Content Network
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
It is then possible to measure the skew between the input trigger and the local clock and adjust the vernier delay on a shot-by-shot basis, to compensate for most of the trigger-to-clock jitter. Jitter in the tens of picoseconds RMS can be achieved with careful calibration. Stanford Research Systems use this technique.
In that approach, the measurement is an integer number of clock cycles, so the measurement is quantized to a clock period. To get finer resolution, a faster clock is needed. The accuracy of the measurement depends upon the stability of the clock frequency. Typically a TDC uses a crystal oscillator reference frequency for good long term stability.
MEMS clock generators are MEMS timing devices with multiple outputs for systems that need more than a single reference frequency. MEMS oscillators are a valid alternative to older, more established quartz crystal oscillators , offering better resilience against vibration and mechanical shock, and reliability with respect to temperature variation.
In optics, jitter is used to refer to motion that has high temporal frequency relative to the integration/exposure time. This may result from vibration in an assembly or the unstable hand of a photographer. Jitter is typically differentiated from smear, which has a lower frequency relative to the integration time. [1]
Time: The interval between two events present on the worldline of a single clock is called proper time, an important invariant of special relativity. As the origin of the muon at A and the encounter with Earth at D is on the muon's worldline, only a clock comoving with the muon and thus resting in S′ can indicate the proper time T′ 0 =AD.
Here, the contamination delay is the amount of time needed for a change in the flip-flop clock input to result in the initial change at the flip-flop output (Q). If there is insufficient delay from the output of the first flip-flop to the input of the second, the input may change before the hold time has passed. Because the second flip-flop is ...