Search results
Results From The WOW.Com Content Network
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active device or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage (voltage gain), current (current gain) or electric power (power ...
The use of the term ground (or earth) is so common in electrical and electronics applications that circuits in portable electronic devices, such as cell phones and media players, as well as circuits in vehicles, may be spoken of as having a "ground" or chassis ground connection without any actual connection to the Earth, despite "common" being ...
Nonetheless, the voltage gain is appreciable even for small loads: according to the table, with R S = r E the gain is A v = g m R L / 2. For larger source impedances, the gain is determined by the resistor ratio R L / R S, and not by the transistor properties, which can be an advantage where insensitivity to temperature or transistor variations ...
In electronics, a virtual ground (or virtual earth) is a node of a circuit that is maintained at a steady reference potential, without being connected directly to the reference potential. In some cases the reference potential is considered to be that of the surface of the earth, and the reference node is called "ground" or "earth" as a consequence.
In the non-inverting amplifier on the right, the presence of negative feedback via the voltage divider R f, R g determines the closed-loop gain A CL = V out / V in. Equilibrium will be established when V out is just sufficient to pull the inverting input to the same voltage as V in. The voltage gain of the entire circuit is thus 1 + R f / R g.
Because of virtual ground at the negative input of the amplifier , ¯ = ¯ holds. We therefore get for the root mean square (RMS) noise output voltage , ¯ =. A high feedback resistor is desirable because the transimpedance of the amplifier grows linearly with the resistance but the output noise only grows with the square root of the feedback ...
In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an ...
The antenna gain, or power gain of an antenna is defined as the ratio of the intensity (power per unit surface area) radiated by the antenna in the direction of its maximum output, at an arbitrary distance, divided by the intensity radiated at the same distance by a hypothetical isotropic antenna which radiates equal power in all directions.