When.com Web Search

  1. Ads

    related to: tire plugs for large holes in concrete floor anchors

Search results

  1. Results From The WOW.Com Content Network
  2. Wall plug - Wikipedia

    en.wikipedia.org/wiki/Wall_plug

    Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...

  3. Anchor bolt - Wikipedia

    en.wikipedia.org/wiki/Anchor_bolt

    Other uses include anchoring machines to poured concrete floors [7] and buildings to their concrete foundations. Various typically disposable aids, mainly of plastic, are produced to secure and align cast-in-place anchors prior to concrete placement. Moreover, their position must also be coordinated with the reinforcement layout. [3]

  4. Tieback (geotechnical) - Wikipedia

    en.wikipedia.org/wiki/Tieback_(geotechnical)

    Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.

  5. Rail fastening system - Wikipedia

    en.wikipedia.org/wiki/Rail_fastening_system

    Rusted chair screw Chair screw (French: Tire-fonds) A chair screw (also known as coach screw [16]) is a large (~6 in or 152 mm length, slightly under 1 in or 25 mm diameter) metal screw used to fix a chair (for bullhead rail), baseplate (for flat bottom rail) or to directly fasten a rail. Chair screws are screwed into a hole bored in the ...

  6. Tie rod - Wikipedia

    en.wikipedia.org/wiki/Tie_rod

    The ends of the rods are secured by anchor plates which may be visible from the outside. The rebar used in reinforced concrete is not referred to as a "tie rod", but it essentially performs some of the same tension-force-counteracting purposes that tie rods perform. In automobiles, the tie rods are part of the steering mechanism. They differ ...

  7. Anchor - Wikipedia

    en.wikipedia.org/wiki/Anchor

    A stream anchor, which is usually heavier than a kedge anchor, can be used for kedging or warping in addition to temporary mooring and restraining stern movement in tidal conditions or in waters where vessel movement needs to be restricted, such as rivers and channels. [43] Charts are vital to good anchoring. [44]

  1. Ad

    related to: tire plugs for large holes in concrete floor anchors