When.com Web Search

  1. Ads

    related to: 3 4x22 pvc condensate traps 50

Search results

  1. Results From The WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  3. Solar still - Wikipedia

    en.wikipedia.org/wiki/Solar_still

    The shade produced by the lid also reduces the temperature within the trap, which further reduces the rate of water loss to evaporation. A solar still can be constructed with two–four stones, plastic film or transparent glass, a central weight to make the funnel and a container for the condensate. [3] Better materials improve efficiency.

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]

  5. Condensing boiler - Wikipedia

    en.wikipedia.org/wiki/Condensing_boiler

    The condensate expelled from a condensing boiler is acidic, with a pH between 3 and 4. Condensing boilers require a drainpipe for the condensate produced during operation. This consists of a short length of polymer pipe with a vapour trap to prevent exhaust gases from being expelled into the building.

  6. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". Examples of traps [further explanation needed] In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials to pass ...

  7. Cold trap - Wikipedia

    en.wikipedia.org/wiki/Cold_trap

    [3] [4] Reversing this, connecting the down tube to the source of vacuum, places the inlet of the vacuum directly above the condensate, increasing the chances of vapour phase condensate moving up the (uncooled) down tube (towards the pump) or, should the trap begin to fill to an appreciable volume, liquid phase condensate being pulled into the ...