Ads
related to: self tapping galvanized roofing screws
Search results
Results From The WOW.Com Content Network
A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .
self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole. The advantage of this screw type over a self-drilling screw is that, if the screw is reinstalled, new threads are not cut as the screw is driven. set bolt
A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...
Thread rolling screws for metric ISO thread – Part 1: Types, designation, requirements: Active: DIN 7500-2: Thread rolling screws for ISO metric thread; guideline values for hole diameters: Active: DIN 7504: Self-drilling screws with tapping screw thread – Dimensions, requirements and testing: Withdrawn: ISO 10666, ISO 15480, ISO 15481, ISO ...
The Phillips/square screw drive, also known as the Quadrex, Pozisquare screw drive, is a combination of the Phillips and Robertson screw drives. While a standard Phillips or Robertson tool can be used, there is also a dedicated tool for it that increases the surface area between the tool and the fastener so it can handle more torque.
Where L e is the thread engagement length, A t is the tensile stress area, D is the major diameter of the screw, and p is the pitch. This equation only holds true if the screw and female thread materials are the same. If they are not the same, then the following equations can be used to determine the additional thread length that is required: [14]