Search results
Results From The WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software.
The user's computer has an IP address stuffed manually into its address table (normally with the arp command with the MAC address taken from a label on the device) The computer sends special packets to the device, typically a ping packet with a non-default size. The device then adopts this IP address
The traceroute command can be implemented by transmitting IP datagrams with specially set IP TTL header fields, and looking for ICMP time exceeded in transit and destination unreachable messages generated in response. The related ping utility is implemented using the ICMP echo request and echo reply messages.
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
There are two primary types of IP addresses in use today: IP version 4 (IPv4) and IP version 6 (IPv6). The former has been around since January 1983 , and is still the most common.
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility.
Requests the direct IP address of the user with the specified nickname. This command is often used to obtain the IP of an abusive user to more effectively perform a ban. It is unclear what, if any, privileges are required to execute this command on a server. This command is not formally defined by an RFC, but is in use by some IRC daemons.
Most email software and applications have an account settings menu where you'll need to update the IMAP or POP3 settings. When entering your account info, make sure you use your full email address, including @aol.com, and that the SSL encryption is enabled for incoming and outgoing mail.