Ad
related to: feet and inch to decimal conversion chart size
Search results
Results From The WOW.Com Content Network
Its exact size varied from city to city and could range between 270 mm (10.6 in) and 350 mm (13.8 in), but lengths used for temple construction appear to have been about 295 mm (11.6 in) to 325 mm (12.8 in); the former was close to the size of the Roman foot.
The following table lists the units of the Jeffersonian decimal system, and their relationship with one another. The values of these units are based on Jefferson's proposal of a foot that was equal in length to one-fifth of a second rod, one fourth of an inch shorter than the foot in use at the time, and approximately equal to 0.298461684 m. [5]
The table of imperial avoirdupois mass is the same as the United States table up to one pound, but above that point, the tables differ. The imperial system has a hundredweight, defined as eight stone of 14 lb each, or 112 lb ( 50.802 345 44 kg ), whereas a US hundredweight is 100 lb ( 45.359 237 kg ).
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
The agricultural foot was reduced to 10 ⁄ 11 of its former size, causing the rod, pole or perch to become 16 + 1 ⁄ 2 (rather than the older 15) agricultural feet. The furlong and the acre, once it became a measure of the size of a piece of land rather than its value, remained relatively unchanged. In the last thousand years, three principal ...
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.
Computer fan sizes are exclusively referred to by metric units (120 mm or 80 mm case fans, for example), while hard disk drive and CD drive bay sizes are customary measurements, typically 3 1 ⁄ 2 inches and 5 1 ⁄ 4 inches, respectively. The actual size of the drive bays differ from their name (e.g., 3 1 ⁄ 2" drive bays are actually 4 ...
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.