When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.

3. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In the United States, plumbing codes usually provide strict limitations on how far a trap may be located from the nearest vent stack. When a vent cannot be provided, an air admittance valve may be used instead. These devices avoid negative pressure in the drain pipe by venting room air into the drain pipe (behind the trap).

4. Garden hose - Wikipedia

   en.wikipedia.org/wiki/Garden_hose

   A coiled garden hose. A garden hose, hosepipe, or simply hose is a flexible tube used to convey water. There are a number of common attachments available for the end of the hose, such as sprayers and sprinklers (which are used to concentrate water at one point or to spread it over a large area). Hoses are usually attached to a hose spigot or tap.

5. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Copper piping system in a building. The major categories of plumbing systems or subsystems are: [19] potable cold and hot tap water supply; plumbing drainage venting; sewage systems and septic systems with or without hot water heat recycling and graywater recovery and treatment systems; Rainwater, surface, and subsurface water drainage; fuel ...

6. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   A duct system often begins at an air handler. The blowers in the air handler can create substantial vibration, and the large area of the duct system would transmit this noise and vibration to the inhabitants of the building. To avoid this, vibration isolators (flexible sections) are normally inserted into the duct immediately before and after ...

7. Three-point hitch - Wikipedia

   en.wikipedia.org/wiki/Three-point_hitch

   The two lower arms—the hitch lifting arms—are controlled by the hydraulic system, and provide lifting, lowering, and even tilting to the arms. The upper center arm—called the top link—is movable, but is usually not powered by the tractor's hydraulic system. Each arm has an attachment device to connect implements to the hitch.