Search results
Results From The WOW.Com Content Network
The clutch's input shaft is typically attached to a motor, while the clutch's output shaft is connected to the mechanism that does the work. In a motor vehicle, the clutch acts as a mechanical linkage between the engine and transmission. By disengaging the clutch, the engine speed (RPM) is no longer determined by the speed of the driven wheels.
The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at different speeds. In the extreme, clutch control is used in performance driving, such as starting from a dead stop with the engine producing maximum torque at high RPM.
Once the engine has turned over and is running, the overrun clutch releases the starter from the flywheel and prevents the gears from re-meshing (as in an accidental turning of the ignition key) while the engine is running. A freewheel clutch is now used in many motorcycles with an electric starter motor. It is used on many combustion-engined ...
Dual-mass flywheel section. A dual-mass flywheel (DMF or DMFW) is a rotating mechanical device that is used to provide continuous energy (rotational energy) in systems where the energy source is not continuous, the same way as a conventional flywheel acts, but damping any violent variation of torque or revolutions that could cause an unwanted vibration.
These limited-slip differentials use helical gears, clutches or cones (an alternative type of clutch) where the engagement force of the gears or clutch is a function of the input torque applied to the differential (as the engine applies more torque the gears or clutches grip harder and Trq d increases).
Differential operation while turning left: Input torque is applied to the ring gear (purple), which rotates the carrier (purple) at the same speed. The left sun gear (red) provides more resistance than the right sun gear (yellow), which causes the planet gear (green) to rotate anti-clockwise.
The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec). When the current is removed from the clutch, the armature is free to turn with the shaft. Springs hold the friction disks away from each other, so there is no contact when the clutch is not engaged, creating a minimal amount of ...
When the engine reaches a certain speed, the clutch activates, working somewhat like a continuously variable transmission. As the load increases, the speed drops, disengaging the clutch, letting the speed rise again, and reengaging the clutch. If tuned properly, the clutch will tend to keep the speed at or near the torque peak of the engine.