Ads
related to: hacks for hiding computer wires and connectors free patterns made from yarn- Deals in Electronics
Find Deals On Popular Electronics
Shop Cameras, Headphones & more
- Alexa Built-in Devices
Deals On Alexa Built-in Devices
Instantly Connect to Music and News
- Home Audio
Huge Selection and Great Prices
Home Theaters, Premium Audio & More
- Shop Amazon Devices
Explore All New Amazon Devices
Fire TV, Echo & Smart Home Devices
- Wearable Technology
Discover the Best Wearable Tech
Smartwatches, Glasses & Accessories
- Explore Amazon Smart Home
Shop for smart home devices that
work with Alexa. See our guide too.
- Deals in Electronics
Search results
Results From The WOW.Com Content Network
Cable lacing is a method for tying wiring harnesses and cable looms, traditionally used in telecommunication, naval, and aerospace applications. This old cable management technique, taught to generations of lineworkers , [ 1 ] is still used in some modern applications since it does not create obstructions along the length of the cable, avoiding ...
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
These wires are called wire bridges or jumpers, but unlike jumpers used for configuration settings, they are intended to permanently connect the points in question. They are used to solve layout issues of the printed wiring, providing connections that would otherwise require awkward (or in some cases, impossible) routing of the conductive traces.
Manual wire wrapping/stripping tool. A correctly made wire-wrap connection for 30 or 28 AWG wire is seven turns (fewer for larger wire) of bare wire with half to one and a half turns of insulated wire at the bottom for strain relief. [3] [4] The square hard-gold-plated post thus forms 28 redundant contacts. The silver-plated wire coating cold ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
A split-50 M-type 66 block with bridging clips attached. A 66 block is a type of punch-down block used to connect sets of wires in a telephone system. They have been manufactured in four common configurations, A, B, E and M. [a] A and B styles have the clip rows on 0.25" centers while E and M have the clip rows on 0.20" centers.
A patch cable is an electrical or optical cable used to connect one electronic or optical device to another for signal routing. Devices of different types (e.g. a switch connected to a computer, or a switch connected to a router) are connected with patch cables.
Thunderbolt (interface) also supports daisy-chained devices such as RAID arrays and computer monitors. [3] DisplayPort 1.2 and higher features Multi-Stream Transport (MST) mode. In this mode, multiple screens can be connected either using a hub or as a daisy chain. The Hexbus is the 10-wire bus of Texas Instruments, used in the TI-99/4A, CC-40 ...