When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

3. Bendix-Stromberg pressure carburetor - Wikipedia

   en.wikipedia.org/wiki/Bendix-Stromberg_pressure...

   and so on up to a size 18 (Base number 1 + 17 for the seventeen 1/4 inch increments over the 1 inch base). Lastly, 3/16 inch is added to the coded size for the actual finished bore diameter. Using the size number 18 bore as an example, we can calculate the actual bore size as follows: The first inch is represented by the base number one, and we ...

4. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The hydraulic pressure created by moving a piston (inside the bore of the master cylinder) toward the slave cylinder(s) compresses the fluid evenly, but by varying the comparative surface area of the master cylinder and each slave cylinder, one can vary the amount of force and displacement applied to each slave cylinder, relative to the amount ...

5. List of John Deere tractors - Wikipedia

   en.wikipedia.org/wiki/List_of_John_Deere_tractors

   The main engine is a two-cylinder, four-stroke, naturally-aspirated 416 cu in (6.8 L) (5.75 by 8.00 in (146 by 203 mm) bore and stroke), direct injected diesel engine, with a 16:1 compression ratio. The starting engine is also a John Deere two-cylinder, 26 cu in (0.43 L) horizontally opposed gasoline engine. The starting or "pony" engine is ...

6. Position-sensing hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Position-sensing_hydraulic...

   The machining and additional production steps associated with “gun drilling” the piston rod can add cost to the finished cylinder. Magnetostrictive LDTs provide extremely high accuracy, down to one micron. [3] Hydraulic cylinder with a Hall effect sensor mounted along its barrel to sense position of a magnetic piston inside. The sensor is ...

7. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.