Search results
Results From The WOW.Com Content Network
A boiling tube is a large test tube intended specifically for boiling liquids. A test tube filled with water and upturned into a water-filled beaker is often used to capture gases, e.g. in electrolysis demonstrations. A test tube with a stopper is often used for temporary storage of chemical or biological samples.
A Thiele tube can be used to measure the boiling point of a liquid by the Siwoloboff method. A sample in a fusion tube is attached to a thermometer with a rubber band, and immersed in the tube. A sealed capillary, open end pointing down, is placed in the fusion tube. The Thiele tube is heated; dissolved gases evolve from the sample first.
Internally rifled boiler tubes are used to evaporate water into steam inside boilers of thermal power plants. Because of their internally rifled shape, they are more efficient. The boiling crisis takes place later, thus allowing for greater heat transfer between the pipe and the fluid inside the pipe.
These tubes are usually made of glass, but can also be made of plastic or metal. They vary in size and purpose. Laboratory sample tubes must not be confused with glass tubing, which can be utilized to carry fluid between laboratory equipment. Example laboratory sample tubes are listed below: Ignition tube; Test tube; Boiling tube; NMR tube
While the outward designs of apparatuses can vary greatly, most apparatuses use a sample loaded into a sealed capillary tube (melting-point tube), which is then placed in the apparatus. The sample is then heated, either by a heating block or an oil bath, and as the temperature increases, the sample is observed to determine when the phase change ...
A Thiele tube is an alternative heating vessel. The Siwoloboff method is used to determine the boiling point of small samples of liquid chemicals. A sample in an ignition tube (also called a fusion tube) is attached to a thermometer with a rubber band, and immersed in a Thiele tube, water bath, or other suitable medium for heating. A sealed ...
The most common way of preventing bumping is by adding one or two boiling chips to the reaction vessel. However, these alone may not prevent bumping and for this reason it is advisable to boil liquids in a boiling tube, a boiling flask, or an Erlenmeyer flask. In addition, heating test tubes should never be pointed towards any person, just in ...
Hand boiler toy, built into a ballpoint pen. The warmth from the fingertips increases air pressure inside the tube, causing the liquid to rise and bubble up into the top chamber as if the liquid was boiling.