When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Mason's miter - Wikipedia

   en.wikipedia.org/wiki/Mason's_miter

   Mason's mitre in a kitchen countertop. A mason's mitre is a type of mitre joint, traditionally used in stonework or masonry but commonly seen in kitchen countertops.In a mason's mitre, the two elements being joined meet as for a butt joint but a small section of one member is removed creating a socket to receive the end of the other.

3. Countertop - Wikipedia

   en.wikipedia.org/wiki/Countertop

   Countertops are custom made and more scratch resistant as well as less porous than natural quartz surfaces, and don't need to be sealed like other stone surfaces. Due to the presence of the resins, quartz counters are less prone to staining. Thicknesses may be 6mm, 1.2 cm (1/2 inch), 2 cm (3/4 inch), 3 cm (1¼ inch) or 4 cm (1½ inch).

4. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   Miter gauge: The table has one or two slots (grooves) running from front to back, also parallel to the cutting plane of the blade. These miter slots (or miter grooves) are used to position and guide either a miter gauge (also known as a crosscut fence) or crosscut sled. The miter gauge is usually set to be at 90 degrees to the plane of the ...

5. Miter saw - Wikipedia

   en.wikipedia.org/wiki/Miter_saw

   A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...

6. Butt joint - Wikipedia

   en.wikipedia.org/wiki/Butt_joint

   There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.

7. Bevel - Wikipedia

   en.wikipedia.org/wiki/Bevel

   Side views of a bevel (above) and a chamfer (below). A bevelled edge (UK) or beveled edge (US) is an edge of a structure that is not perpendicular to the faces of the piece. . The words bevel and chamfer overlap in usage; in general usage, they are often interchanged, while in technical usage, they may be differentiated as shown in the image on the ri