Search results
Results From The WOW.Com Content Network
Noise figure (NF) and noise factor (F) are figures of merit that indicate degradation of the signal-to-noise ratio (SNR) that is caused by components in a signal chain.These figures of merit are used to evaluate the performance of an amplifier or a radio receiver, with lower values indicating better performance.
Friis's formula is used to calculate the total noise factor of a cascade of stages, each with its own noise factor and power gain (assuming that the impedances are matched at each stage). The total noise factor can then be used to calculate the total noise figure. The total noise factor is given as
If the noise has expected value of zero, as is common, the denominator is its variance, the square of its standard deviation σ N. The signal and the noise must be measured the same way, for example as voltages across the same impedance. Their root mean squares can alternatively be used according to:
Received noise power, noise at a telecommunications receiver; Circuit noise level, ratio of circuit noise to some reference level; Channel noise level, some measure of noise in a communication channel; Noise-equivalent target, intensity of a target when the signal-to-noise level is 1 [2] Equivalent noise resistance, a measure of noise based on ...
Different types of noise are generated by different devices and different processes. Thermal noise is unavoidable at non-zero temperature (see fluctuation-dissipation theorem), while other types depend mostly on device type (such as shot noise, [1] [3] which needs a steep potential barrier) or manufacturing quality and semiconductor defects, such as conductance fluctuations, including 1/f noise.
Noise experts and some small specialized companies have slowly developed a limited number of calculation tools, which have increased in number and become more user-friendly, covering more application cases, and adding service elements to the noise calculation tools. The noise calculation process is complex in input (gathering data, correctly ...
"Attenuators have a noise factor F equal to their attenuation ratio L" I just can't see how this can be correct, for example an attenuator made of capacitors (voltage divider) will not introduce any new noise so the SNRin and SNRout will be the same, therfore the noise figure of such an attenuator will be zero, I am sure that there are many other examples where the NF is zero or irrelevant.
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...