Ads
related to: sailing mast head unit
Search results
Results From The WOW.Com Content Network
A UFO 34 an example of a masthead-rigged yacht. A masthead rig on a sailing vessel consists of a forestay and backstay both attached at the top of the mast. [1] The Bermuda rig can be split into two groups: the masthead rig and the fractional rig. The masthead rig has larger and more headsails, and a smaller mainsail, compared to the fractional ...
The top of a triangular sail, the head, is raised by a halyard, The forward lower corner of the sail, the tack, is shackled to a fixed point on the boat in a manner to allow pivoting about that point—either on a mast, e.g. for a mainsail, or on the deck, e.g. for a jib or staysail.
If the mast has a long, thin cross-section and makes up a significant area of the airfoil, it is called a wing-mast; boats using these have a smaller sail area to compensate for the larger mast area. There are many manufacturers of modern masts for sailing yachts of all sizes, a few notable companies are Hall Spars, Offshore Spars, and Southern ...
The rig consists of a triangular sail set abaft (behind) the mast with its head raised to the top of the mast; its luff runs down the mast and is normally attached to it for its entire length; its tack is usually attached to the gooseneck; its foot (in modern versions of the rig) controlled by a boom; and its clew attached to the after end of ...
A sail batten is a flexible insert in a fore-and-aft sail that provides added stiffness and definition to the sail's airfoil cross-section. [1] The most common use of sail battens is in the roach of a mainsail. The batten extends the leech past the line that runs from the head and the clew of the sail to create a wider sail towards the top.
Many mast-aft rigs utilize a small mainsail and multiple staysails that can resemble some cutter rigs. A cutter is a single masted vessel, differentiated from a sloop either by the number of staysails, with a sloop having one and a cutter more than one, or by the position of the mast, with a cutter's mast being located between 50% and 70% of the way from the aft to the front of the sailplan ...
Beneteau 361 showing its walk-through reverse transom.. The Beneteau 361 is a recreational keelboat, built predominantly of fiberglass.It has a masthead sloop rig, a raked stem, a walk-through reverse transom an internally-mounted spade-type rudder controlled by a wheel and a fixed fin bulb keel.
The top three yards of the fore- and main masts are moveable, and are kept lowered when not sailing to lower the ship's center of gravity. In addition, the top portion of the fore- and main masts, known as the topgallant masts, may be housed (lowered) by 13 ft when not under sail in order to sail underneath low bridges.