Search results
Results From The WOW.Com Content Network
In a schooner with two masts, even if the masts are of the same height, the after one usually carries a larger sail (because a longer boom can be used), so the after mast is the mainmast. This contrasts with a ketch or a yawl , where the after mast, and its principal sail, is clearly the smaller of the two, so the terminology is (from forward ...
The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc. Even a full-rigged ship did not usually have a lateral (square) course on the mizzen mast below the mizzen topmast.
8 – mast 9 – spreader 10 – shroud 11 – sheet 12 – boom 13 - mast 14 – spinnaker pole 15 – backstay 16 – forestay 17 – boom vang Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. [1]
Either of the braces attached to the yard of the mainsail (the largest and lowest sail on the mainmast) on a square-rigged vessel. mainmast. Also simply main. 1. The tallest mast on a ship [1] with more than one mast, especially the tallest mast on a full-rigged ship. 2. On a ship with more than one mast, the second mast from the bow. mainmast head
The mast is said to be supported like a "tripod", with swept-back spreaders and a forestay. Used widely on Hunter brand sailboats, among others. Designed and named by Lars Bergstrom and Sven Ridder. [citation needed] back 1. To make a sail fill with wind on the opposite side normally used for sailing forward.
A traditional ship's mast, consisting of "lower" (i.e. Main-, Fore- or Mizzen-) mast, topmast and topgallant/royal mast. The topmast is highlighted in red. The masts of traditional sailing ships were not single spars, but were constructed of separate sections or masts, each with its own rigging. The topmast is one of these.
Standing rigging comprises the fixed lines, wires, or rods, which support each mast or bowsprit on a sailing vessel and reinforce those spars against wind loads transferred from the sails. This term is used in contrast to running rigging , which represents the moveable elements of rigging which adjust the position and shape of the sails.
Mast stepping is the process of raising the mast of a boat. It may be a ceremonial occasion on a new boat, a necessary step (as in stepping the mast of a small sailing dinghy or gig), or simply routine (as following seasonal maintenance on a sailboat).