Ads
related to: 1 inch metal buttons
Search results
Results From The WOW.Com Content Network
A pin-back button or pinback button, pin button, button badge, or simply pin-back or badge, is a button or badge that can be temporarily fastened to the surface of a garment using a safety pin, or a pin formed from wire, a clutch or other mechanism. This fastening mechanism is anchored to the back side of a button-shaped metal disk, either flat ...
Buttons are commonly measured in lignes (also called lines and abbreviated L), with 40 lines equal to 1 inch. [27] For example, some standard sizes of buttons are 16 lignes (10.16 mm, standard buttons of men's shirts ) and 32 lignes (20.32 mm, typical button on suit jackets ).
The button is approximately 7/16 inch in height and 5/8 inch in width. A cloth lozenge depicting the gold colored button design was also issued. The lozenge was approximately 1.5 inches in height and 3 inches in width with the ring design being approximately 1 inch in diameter.
The two halves of a riveted leather snap fastener. The top half has a groove which "snaps" in place when "pressed" into the bottom half. A snap fastener, also called snap button, press button, [1] press stud, [1] press fastener, dome fastener, popper, snap and tich (or tich button), is a pair of interlocking discs, made out of a metal or plastic, commonly used in place of traditional buttons ...
1.3 Rocks and minerals ... pot metal sterling silver steel [16] ... The Collector's Encyclopedia of Buttons. Atglen, PA: Schiffer. p. 242.
Button, coin, or watch cells. A button cell, watch battery, or coin battery is a small battery made of a single electrochemical cell and shaped as a squat cylinder typically 5 to 25 mm (0.197 to 0.984 in) in diameter and 1 to 6 mm (0.039 to 0.236 in) high – resembling a button.
Ads
related to: 1 inch metal buttons