Search results
Results From The WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
QinQ allows multiple VLAN tags to be inserted into a single frame, an essential capability for implementing metro Ethernet. In a multiple-VLAN-header context, out of convenience, the term VLAN tag or just tag for short is often used in place of 802.1Q VLAN header. QinQ allows multiple VLAN tags in an Ethernet frame; together these tags ...
A virtual local area network (VLAN) is any broadcast domain that is partitioned and isolated in a computer network at the data link layer (OSI layer 2). [2] [3] In this context, virtual refers to a physical object recreated and altered by additional logic, within the local area network. Basically, a VLAN behaves like a virtual switch or network ...
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
There is a need to preserve IP addressing. With Private VLANs, all Secondary VLANs can share the same IP subnet. Overcome license fees for number of supported VLANs per firewall. [5] There is a need for more than 4095 segregated networks. With Isolated VLAN, there can be endless number of segregated networks. [6]
Protocol stack of the OSI model. The protocol stack or network stack is an implementation of a computer networking protocol suite or protocol family.Some of these terms are used interchangeably but strictly speaking, the suite is the definition of the communication protocols, and the stack is the software implementation of them.
A multilayer switch can prioritize packets by the 6 bit differentiated services code point (DSCP). These 6 bits were originally used for type of service. The following 4 mappings are normally available in an MLS: [citation needed] From OSI layer 2, 3 or 4 to IP DSCP (for IP packets) or IEEE 802.1p; From IEEE 802.1p to IP DSCP; From IP DSCP to ...
Layer 3 redundancy. Some stackable architectures allow for continued Layer 3 routing if there is a “down” switch in a stack. If routing is centralized in one unit in the stack, and that unit fails, then there must be a recovery mechanism to move routing to a backup unit in the stack. Mix and match of technology.