Search results
Results From The WOW.Com Content Network
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
M-series chassis use a Dana 60 or 70 or Spicer M70 solid rear axles with leaf springs. Frames were used by Winnebago , Champion , Apollo MotorHomes and several other RV manufacturers. The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [ 1 ] M-500, and M-600 depending on the application.
The M1009 Blazer used 10-bolt axles (front and rear) featuring 3.08:1 gears. The rear axle was equipped with an Eaton Automatic Differential Lock (ADL) while the front was a standard open differential. The M1008 trucks used open Dana 60 front axles, with the M1028
All Dana 70 rear axles are full floating and typically have a gross axle rating of 7,500 lb (3,400 kg). The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts.
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
This axle is referred to as a Dana 44 ICA or Dana 44 IRS. All 1980–1982 Chevrolet Corvette C3 and manual transmission equipped 1985–1996 Chevrolet Corvette C4 had this axle. The 2005–06 Pontiac GTO, The Dodge Viper has always used a Dana 44 IRS setup. The majority of Corvette and Viper Dana 44 IRS set ups use a limited slip differential.
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...
Center axle disconnect on a Dana 60, in a 1999 4x4 Dodge 2500HD. A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles. A CAD system works by having an axle shaft (typically the longer shaft) split into two pieces.